16 May 2014

President Lincoln II Version 3



Simon The Wizard gets his hands on a V3 Lincoln 2!

Posted by at

3 comments:

  1. Unknown1 December 2014 at 18:36

    Hi can you tell me how to access the engineers menu on the Lincoln 2 as my radio 100hertz low on SSB.

    Regards Mark

    ReplyDelete
  2. Delboy2 December 2014 at 11:28

    I have so far refrained from posting this information but as someone else has recently posted a video on YouTube showing how to access the engineering menu:

    Press and hold the UP and DOWN channel buttons when powering on the radio.

    Press the UP channel button to get to number 06

    Press the channel change knob in.

    Press the MODE button to get to the mode you wish to adjust I.E. USB

    The display shows BFO USB with a number next to it. Make a note of this number in case you need to put it back!

    Adjust the number up/down with the channel change knob to adjust the frequency.

    Turn radio off then back on again.

    Repeat until all modes are on frequency.

    BE VERY CAREFUL - Do not adjust any other settings, Do not press any other buttons. You can seriously F**K UP your radio!!!!

    You have been warned!!!!!!!!

    ReplyDelete
  3. Unknown2 December 2014 at 23:09

    Cheers delboy just hate it when a radio is off on SSB thanks for your info it's much appreciated.

    Regards Mark

    ReplyDelete

Subscribe to: Post Comments (Atom)