Pages

▼

13 February 2019

President Bill Service Menu Secrets

Video:YouTube/Klaus R.

An interesting video showing differences between the FCC and EU versions of the President Bill along with some 'service menu' secrets.

In common with most of the newer CB radios from President there are no adjustments available inside the radio so it's obvious that any adjustments have to made via either software or a hidden service menu. I would expect that most if not all of the recent radios will have such a hidden service menu....


at

12 comments:

  1. tgreen21 June 2019 at 05:34

    Ok, how do we access the service menu?

    ReplyDelete
  2. butterfingers10 November 2019 at 20:59

    The service menu is accessed by holding down the PTT, CB/WX Alert, and EMG buttons and then turning on the power switch. With a stock radio, the service menu displays two parameters; PL and AL. PL is power and AL is audio. Larger values for PL increase carrier power and smaller values of AL increase modulation. If you have modified the radio per this link: http://radioaficion.com/cms/president-bill-fcc-mods/ then the service menu displays four parameters PM, PL, AM, and AL. In this service menu, PM is carrier power and AM is modulation. PL and AL do nothing. With the modification given in the link, about 8 watts of carrier is possible. The audio driver is insufficient to drive 8 watts of carrier into good modulation levels. So it is better to adjust the carrier to a lower value which will allow modulation levels around 90% to 95%

    ReplyDelete
    Replies
    1. Unknown26 January 2021 at 01:05

      What was the best settings you found for the PL and AL

      Delete
    2. Unknown26 January 2021 at 01:06

      also what is the factory settings for the PL and AL

      Delete
    3. Grigori R11 July 2021 at 05:55

      Once you get it into where it will do "PM" or "AL", how do you actually adjust the audio or power up or down? I know this sounds like a stupid question but I honestly cannot get any functions to happen beyond the point where you select "PL" or "AL". I have the FCC (USA) models. I read elsewhere that factory default is 2 or 2.5 Watts and that using the hidden menu, you can make it go up to 3.9 Watts, where it should be.

      Any help appreciated.

      Delete
    4. Soprano Productions8 July 2022 at 23:46

      How do you do it on the Andy ll

      Delete
  3. Dx Radio Shop2 June 2020 at 16:48

    how to change the values

    ReplyDelete
  4. ickenbone15 January 2021 at 14:03

    Thank you for the information on accessing the service menu. I was able to follow the steps and turn on the service menu but I cannot figure out how to adjust the values. There must be some combination of buttons you have to push in order to change the values.

    ReplyDelete
    Replies
    1. Anonymous26 February 2021 at 22:17

      with up down on display button

      Delete
    2. SteveL3327 April 2021 at 23:43

      Hold the PTT button, then press the channel up/down buttons

      Delete
    3. ruffino3313 December 2021 at 16:36

      Will Not Work, what Else to Change the values?
      Thx

      Delete
  5. Simon21 April 2021 at 19:29

    Once you have modified the radio, how do you switch between low and medium power please?

    ReplyDelete